Extraflame Viviana Uživatelský manuál stáhnout pdf (Strana 20)

USER MENU

PELLET FEED ADJUSTMENT

The following menu allows the adjustment of pellet feed as a percentage.

If the stove has functioning problems owing to the quantity of pellets, adjust pellet feeding directly from the control board.

The problems correlated to the amount of fuel can be divided into 2 categories:

NO FUEL:

 the stove can never develop a suitable ame, tending to remain very low even at high powers.

 at minimum power the stove tends to almost switch-o taking the stove into “NO PELLETS” alarm condition.

 when the stove displays the “NO PELLETS” alarm, there may be non-burned pellets inside the burn pot.

EXCESS FUEL:

 the stove develops a very high ame even at low power.

 the panoramic glass is very dirty, obscuring it almost totally.

 the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only

burned partially.

The regulation to be performed is a percentage. Therefore a modication of this parameter will lead to a proportional

variation of all stove feeding speeds. Feeding is from -30% to +20%.

Follow the procedure on the display to perform this adjustment:

NO IGNITION ALARM

FIRST IGNITION COULD EVEN FAIL AS THE AUGER IS EMPTY AND IS NOT ALWAYS ABLE TO LOAD THE BURN POT WITH

THE REQUIRED AMOUNT OF PELLETS ON TIME TO REGULARLY START THE FLAME.

IF THE PROBLEM OCCURS AFTER ONLY A FEW MONTHS WORKING, CHECK THAT ROUTINE CLEANING STATED IN THE

STOVE BOOKLET, HAS BEEN CARRIED OUT CORRECTLY.

ENGLISH

CLEAN CHECK UP 1  2

SHOULD THE ALARM "CLEAN CHECK UP" BE TRIGGERED, MAKE SURE THAT THE

BOTTOM OF THE BURN POT IS FREE OF RESIDUES OR SCALES.

THE HOLES AT THE BOTTOM MUST BE COMPLETELY FREE TO GUARANTEE

CORRECT COMBUSTION.

THE ABOVE INDICATED "PELLET FEED REGULATION" FUNCTION CAN BE USED

TO ADJUST COMBUSTION BASED ON THE DESCRIBED REQUIREMENTS.

IF THE ALARM PERSISTS AND THE ABOVE LISTED CONDITIONS HAVE BEEN

CHECKED, CONTACT THE QUALIFIED AFTERSALES ASSISTANCE CENTRE.

CONTROLS PROCEDURE

 Press key 5 for a few seconds, until the text SET CLOCK appears.

 Press key 3 several times to reach SET USER.

 Conrm using key 5.

 Pellet is displayed.

 By means of the keys 2 and 3 the feeding can be increased (3) or decreased (2) during the WORK phase.

 Press key 1 several times to conrm and exit the Menu.

BURN POT BOTTOM

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Žádné komentáře

Extraflame Viviana Uživatelský manuál Strana 20